ESP32-C3 Super Mini: specs
Small development board built around the ESP32-C3 chip; the specs below are chip-level only, from the ESP32-C3 datasheet.
Specs
| Spec | Value | Source |
|---|---|---|
| Processor | 32-bit RISC-V single-core processor, clock speed up to 160 MHz | source Features, CPU and Memory |
| Wi-Fi | Complies with IEEE 802.11b/g/n, 2.4 GHz band | source Features, Wi-Fi |
| Bluetooth | Bluetooth 5 (LE), Bluetooth mesh | source Features, Bluetooth |
| ROM | 384 KB | source Features, CPU and Memory |
| SRAM | 400 KB (16 KB for cache) | source Features, CPU and Memory |
| Deep-sleep current | 5 µA (power consumption in Deep-sleep mode) | source Features, power modes |
| GPIO count (chip variant) | 22 GPIOs (QFN32 (5*5) package) | source 1.2 Comparison, chip variant table |
| Operating voltage | 3.0 V to 3.6 V (VDD3P3, typical 3.3 V) | source 5.2 Recommended Operating Conditions, Table 5-2 |
| Ambient temperature | -40 to 105 °C (ESP32-C3 variant, QFN32) | source 1.2 Comparison, chip variant table |
Power
| Value | Source | |
|---|---|---|
| Supply | Chip supply VDD3P3 3.0 V to 3.6 V (chip only; board supply is not covered by an official source) | source 5.2 Recommended Operating Conditions, Table 5-2 |
Pinout
We don't publish a pin table for this part: no official source we could verify gives one. Check the labels printed on your module, and see the notes below.
Common mistakes
- Holding GPIO2, GPIO8 or GPIO9 at the wrong level during reset: these pins select the chip boot mode (source)
- Raising VDD3P3_CPU above 3.3 V while writing eFuses: the eFuse circuits are sensitive to higher voltages (source)
- Running the chip supply above 3.6 V: the recommended input range is 3.0 V to 3.6 V (source)
What we could not confirm
- Board is not an Espressif product: the HW-466AB pin layout, 5V pin, USB-C connector and board dimensions have no official source and are omitted.
- Flash size: the listing's 4 MB is a module property. The chip datasheet does not describe board flash, so it is omitted.
- Listing said 12 GPIO pins; not used. The chip variant table gives 22 GPIOs for the QFN32 package.
- Current consumption tables (section 5.6) and per-pin current and voltage limits are not transcribed.
- Listing's 3.7V LiPo note on VBAT is board-level and is not used.
- no official board pinout; pinout withheld. The ESP32-C3 SuperMini is a third-party board; the Espressif DevKitM-1 header is a different board and is not used. The chip datasheet pin table lists chip pins, not board header pins.
Sources
- Espressif ESP32-C3 Series Datasheet v2.4 (official): link.
- Board-level facts (pin layout, flash, USB connector, dimensions) have no official source for this board, which is not an Espressif product.
Building with the ESP32-C3 Super Mini? Describe your project on Soldr: it assigns pins from the board's published pinout, checks power and logic levels, and shows how to wire every part.